Saba ATM 60 artikel-nr.: 133.001 Color: 01 NBF, 1986, made in Germany

 

Link: hifi-wiki | hifi-archiv | hifi-archiv

Generally

- Manufacturer: SABA
- Model: ATM 60
- Year of construction: around 1986
- Made in Germany
- Color: anthracite, oak, walnut
- Dimensions: 540 x 330 x 115 mm (HxWxD)
- Weight:
- New price approx .:

Technical specifications
- Design: 3-way bass reflex
- Chassis:
    - Woofer: 1x 170x170 mm (Planar)
    - Midrange: 1x 115x115 mm (titanium dome)
    - Tweeter: 1x 75x75 mm (titanium dome)
- Power handling (nominal / music): 60/80 watts
- Efficiency:
- Frequency response:
- Transition areas:
- Impedance: 8 ohms

Crown PZM-30-R Boundary Microphones / Pressure Zone Microphone, 1986, made in USA

Link: manualslib [manual, PDF] | soundonsound

SHURE VA-302E6-C Vocal Master Control (6 channel vocal mixer with spring reverb), 1974-1976, made in USA

 

Link: cloudfront | pubs.shure [PDF]

Топовая интернациональная версия, выпускаемая под все виды напруги для любой точки мира.

SPECIFICATIONS

AmplifierType
- All silicon transistor mixer/power amplifier
Power Output
- I00watts continuous '(RMs); (to 8 ohm load, see Figure 3,Page 7)
Voltage Gain
- 80db Input Attenuator "Out" (8 ohm load) 65db lnput Attenuator "In" (8 ohm load)
Frequency Response
- ± 2db 40Hz to 20,000Hz.(typical)
Input Impedance
- 320 ohms lnput Attenuator "Out" 500ohms lnput Attenuator "In"
Distortion
- 5% maximum at rated output at 1KHz.
Hum and Noise
- 60db below rated output
Speaker Load lmpedance
- Nominal 8 ohms; operational 5.3 ohms minimum (See Figure 3,Page 7)
Input Clipping Level
- Greater than 25 Mv. Input Attenuator "Out"
- Greater than 150 Mv. lnput Attenuator "In"
Bass Control Action
- ± 13 db at 100Hz with respect to"flat" setting
TrebleControlAction
- ± 10 db at 10,000Hz with respect to"flat" setting
"Aux. Hi-Level" Output Jack
- Impedance 5,000ohms; Output 19 db below speaker output (to 8 ohm load); nominal - 2V at 50watts to speakers, Clipping Level 4V.
"Mic. Level" Output
- Hi-Z: impedance 1,000ohms; Output 30db below auxiliary output; nominal 60Mv. Clipping Level120 Mv.
- Lo-Z: impedance36ohms; Output 52db below auxiliary output; nominal 5Mv. Clipping Level10 Mv.
Echo-"To Input"Jack(Output To External Echo Unit)
- Impedance 10,000 ohms; O u t p u t 2 0 db above microphone inputs with individual volume sat" 10"; Clipping Level 3V.
Echo-"ToOutput"Jack (Input From External Echo Unit)
- Impedance 40,000 ohms; Sensitivity 200 Mv. for rated amplifier output with "Echo Gain" Control and "Master Volume" Control at maximum settings; Clipping Level 2V. with maximum setting of "Echo Gain" control. Clipping level increases with reduced setting of "Echo Gain" control.
"Reverb Switch"Jack
- D.C.switching (no audio), parallels the Master Reverb
- In-Out Switch. Any cable with a resistance of less
- than 5,000ohms may be used.
Center Notch Frequencies of "Anti-Feedback" Filters
- Filter "A" 5,000Hz.
- Filter "B" 2,200Hz.
- Filter "C" 1,000Hz.
- Filter "D" 155 Hz.
Console (Continued):
- VA302E6-C: 100,120,140,200,220,240volts,50160Hz. Switch selectable.
Power Consumption:
- 80watts maximumwith no signal in. 180 watts with 1 KHz. signal and 100 watts output, 400 watts maximum operating
Ambient Temperature Range
- -7°C. to 43°C. (20" F. to 11O0F.)without derating
Dimensions
- 213 mm height x 635 mm width x 375 mm depth (8% in. x 25 in. x 14% in.)
Weight VA302E-C and VA302E6-C
- 19.05 kg (42 Ib)

Rocktron ProRax MX3 Digital Delay + Waves [rounded or triangle wave], 1988, made in USA

Power Suply: 15 VDC 160mA

rocktron modulation digital delay wave. chorus, flanger pro rax series mx-3 brand new! made in the usa in 1988 as part of rocktron's excellent pro rax series!

this is the only digital delay that i know that has a waveform function- triangle or rounded waves- that can be added to the delay one

you can get nice shimmering lush choruses and flanges added to the delays think andy summers from the police also. very useful to get those 60's and 70's psychedelic wave rotations

very versatile control functions:

1. adjust control

2. source control

3. waveform push button switch(rounded or triangle wave)

4. rate

5. depth

6. regeneration

7. mix(dry/effect)

8. range control

9. input jack

10. two output jacks- excellent for running this unit in stereo between two separate amps to get a 3-dimensional delay for your guitar. vocals, bass, keyboards, or any instrument that you want to add delay to.

11. footswtch jack- any standard footswitch will turn this unit on/off

on the fly great for recording

very quiet if you add this delay to your recordings.

you will get some great stuff. great pedal for 50's slapback through long pink floyd/radiohead delays also can get u2's edge vibes happening here works great in an effects chain- put it at the end of the chain after an overdrive/distortion box- really does a nice job making the overdrive/distortion sing. sounds good with single coil and humbucker pickups sounds good with other effects such as overdrives. phasers, choruses, flangers, etc.

Начинка в лучших традициях американского построения: сплошные RCA + Motorola, ну и логика на Philips

BELL PSX-4022 2-channel power amplifier, 1995, made in Korea

 

Link: elektrotanya

Up to now, high-performance output stages were mostly to be found in one of two classic categories: Universal output stages They only take on the task of linearly amplifying different signals. The listener's physiological perception of loudness is generally neglected. System output stages These usually contain special control modules and are therefore limited to operation within a given PA system (processor system). BELL DSC Technology: Through the development of the revolutionary BELL DSC technology - in connection with generously dimensioned power supplies, the sound quality of every good loudspeaker is dramatically enhanced! While loudspeaker systems - regardless of their design - are usually perceived as sluggish, indirect or imprecise when operated with conventional amplifiers, they develop dynamics on PSX AMPLIFIERS that can hardly be described in words.

Power Output (Stereo):
150+150W / 4Ω
100+100W / 8Ω
Power Output (Mono/Bridge):

300W / 8Ω
THD+N: <0.05% Freaqency Response(10Vrms) : 10Hz – 40kHz S/N Ratio (@ LPF) : >110d

- 10 Hz - 30 KHz / 8 ohms frequency response at 10 Vrms

- 10 Hz - 40 KHz / 8 ohms signal-to-noise ratio (IHF-A) 110 dB

Damping Factor (RL=8Ω, f=400Hz) : ≥200
Voltage Gain (Att. Max) : 29dB
Input Impedance: 10kΩ Unbalanced /20kΩ Balanced
Power Consumption (MAX): 450W
Dimensions (W x H x D) mm: 482 x 88 x 395
Weight: 12kg

* rise speed 3 usec

* input sensitivity 1.23 V rms

* signal display L & R LED

* protection circuit L & R LED

* limit indicator LED cooling system

* Heatsink THD + N <0.1%

* Gain control (channel A & B)

* Power switch, illuminated

* LED function displays

* DSC switch (A / B)

* Input: XLR m, XLR f, symmetrical

* Speaker output L / R: for Speakon NL4FC, Sp.-Output Bridge: for Speakon NL4FC

* Stereo / Bridge switch

* Generously dimensioned power supply unit

* Soft start

* Loudspeaker protection circuit

* Transformer protection circuit

* Power amplifier protection circuit

* Overheating protection

Barcus-Berry model: 1520 Vintage Electric Guitar Mixer/Head/Amplifier (with spring reverb), 1976-1977, made in USA

Link: worldradiohistory [catalogue, PDF]

The Model: 1520 that was made in 1976. The model: 1510 is the same minus the phase shifter. These are for guitar, not bass.

Front Panel / Face Control:
Input:
- Sensitivity
- Volume
Expander:
- Treble
- Bass
Tone:
- Treble
- Bass
Midrange:
- Level
- Frequency
Reverb:
- Volume
- Decay
Master:
- Hi-Z Level
- Lo-Z Level
Phase: (The model: 1510 is the same minus the phase shifter)
- switch on/off
- Speed
- Depth
Power:
- switch Power on/off
- led indicator (red)


Rear Panel:
Monitor:
- 8 Ohm ¼" monitor out
Output:
- Lo-Z XLR out
- ¼" record out
- ¼" Hi-Z out
Foot SW:
- Reverb ¼"
- Accessory ¼"
- Phase ¼"
Echo:
- Send ¼"
- Receive ¼"
Accessory:
- Send ¼"
- Volume control
- Receive ¼"
Tape:
- Volume control
- ¼" Tape Receive
Mixer:
- ¼" Input

All of those features are packed into this compact, lightweight unit that puts out 30 watts RMS of power.