Genelec HT205 / Genelec 1029A / Genelec 8030A Active Studio Reference Monitor, 1999-2006, made in Finland

Link: medias.audiofanzine.com | ACOUSTIC AXIS LOCATION | asktoby [Repair]

Powered speaker pair is the Genelec 1029 (The 1029A was in production between 1996 and 2005. It was replaced by the 8030A) and it’s twin sister the HT205. The difference being that the 1029a has XLR and TRS inputs. The HT205 has XLR and RCA. Genelec 2029a with digital audio input (The 2029A was in production between 1998 and 2005. It was replaced by the 8130A model).

HT205 SYSTEM SPECIFICATIONS

Lower cutoff frequency, -3 dB: < 68 Hz
Upper cutoff frequency, -3 dB: > 20 kHz
Free field frequency response of system: 70 Hz - 18 kHz (± 2.5 dB)
Maximum short term sine wave acoustic output on axis in half space, averaged from 100 Hz to 3 kHz:
- @1m > 100 dB SPL
- @ 0.5 m > 106 dB SPL
Maximum long term RMS acoustic output in same conditions with IEC weighted noise (limited by driver unit protection circuit):
- @1m > 98dBSPL
- @0.5 m >104dBSPL
Maximum peak acoustic output per pair on top of console, @ 1 m from the engineer with music material: > 110 dB
Self generated noise level in free field @ 1m on axis: < 10 dB (A-weighted)
Harmonic distortion at 85 dB SPL @ 1m on axis:
Freq:
- 75...150 Hz < 3%
- > 150 Hz < 1%

Drivers:
Bass: Vifa TC14SG06 8 Ohm Denmark - 130 mm (5") cone

Treble: Vifa D19AD-09-06 6 Ohm Denmark - 19 mm (3/ ") metal dome 4

Both drivers are magnetically shielded

Weight: 5.7 kg / (12.5 lb)

Dimensions:
Height: 247 mm / (9 3/4")
Width: 151 mm / (5 15/16")
Depth: 191 mm / (7 1/2")

AMPLIFIER SECTION

Bass amplifier output power with an 8 Ohm load: 40 W
Treble amplifier output power with an 8 Ohm load: 40 W
Long term output power is limited by driver unit protection circuitry.

Amplifier system distortion at nominal output:
THD: < 0.08%
SMPTE-IM: < 0.08%
CCIF-IM: < 0.08%
DIM 100: < 0.08%

Signal to Noise ratio, referred to full output:
Bass: >90dB
Treble: >90dB

Mains voltage: 100/200 or 115/230 V
Voltage operating range: ±10%

Power consumption:
Idle: 9 VA
Full output: 80 VA

CROSSOVER SECTION

Inputs:
- Input 1: XLR female, balanced 10 kOhm
- Input 2: RCA female, unbalanced 10 kOhm
Volume control: Variable from Mute to -6 dBu for 100 dB SPL output @ 1 m
Subsonic filter below 68 Hz:18 dB/octave
Ultrasonic filter above 25 kHz: 12 dB/octave
Crossover frequency, Bass/Treble: 3.3 kHz
Crossover acoustical slopes: 24 - 32 dB/octave
Treble tilt control operating range: 0 to -2 dB @ 15 kHz
Bass roll-off control operating in a -6 dB step @ 85 Hz
Bass tilt control operating range in -2 dB steps: 0 to-6dB @150Hz
The 'CAL' position is with all tone controls set to 'off' and the input sensitivity control to maximum (fully clockwise).

Genelec - Service Instructions:

Болты, фиксирующие динамики в посадочных местах лицевых отверстий.