Sequence Design 300 Flat Panel HiFi Stereo Speakers, 1998, made in England / UK





Link: audioreference [Sequence Design catalog] | techradar

The Sequence 300 is a medium size, two way, bass reflex loudspeaker system intended primarily for wall mounting. It features a substantially braced MDF cabinet and custom specified drive units.

Bass frequencies are handled by a 140 mm doped paper cone driver while a 25mm fabric dome tweeter gives a smooth, unforced and extended high frequency response. The tuning of the side firing bass ports may be adjusted to optimise the bass response for a given installation.

As front and rear speakers the Sequence 300 can form the basis of an exceptional home theatre system. A single, voice matched, Sequence 200 (200C) is available for horizontal mounting as a centre channel loudspeaker and the SW500 active sub-woofer can be readily adjusted to augment the response of these speakers when used in such a configuration.

A hand wired crossover network and gold plated terminals complete the package and contribute towards the refined, involving and dynamic reproduction of these speakers.

The Sequence 300 may also be used as a floor standing loudspeaker system by adding the proprietary matching plinths and is available in 6 different fabric colours.

Likely to cause a glint in the audiophile's eye... a well deserved thumb's up.
Audiophile


Specification
Sensitivity: 89dB
Impedance: 8 Ohms
Drive Units:
- Bass: 140mm (paper cone)
- Treble: 25mm (fabric dome)
Dimensions (HxWxD): 850x250x70 mm
Power Handling: 60 Watts rms
Frequency Range: 45Hz-20KHz
Orientation on wall: Vertical only


















Комментариев нет:

Отправить комментарий